![]() Klipper lets your print faster with better results. This is what I'm going to run either until I get something like a Le Potato or until RPi prices come down.Įverything is tuned enough to the point where prints look good at high speeds. My RPi died and I have Klipper reinstalled on Raspbian Desktop (branch of Debian 11, I think?). I also haven't tested resonance compensation or linear advance yet, simply not enough time until late today (this edit was made just past 12). Yes I tried adding a "!" in front of the pins for the corisponding fans no it didn't work. I've had this issue before where the polarity on the fans was switched, so I had to switch around the connectors, and that's what I'll try to get it working. I had to solder on connectors (cause with the stock mainboard they just plug into a 24V terminal). Only issue now is that neither the hotend heatsink fan nor the electronics cooling fan turn on. UPDATE: I have the parts installed and (mostly) functional with Klipper running on the MainSail interface. If so, why it's worth it/what the benefits are, what I would need, how hard it is compared to Marling, and any other info worth mentioning? If no, why not, and any other info relating to why It's not/wouldn't be worth it.Īny other general information about Klipper would also be appreciated, positive or negative.Īll new information is appreciated, thanks! My question is if it's worth upgrading to Klipper on the SKR Mini E3. To avoid writing an entire essay in this post, I'll pretend I know nothing about Klipper in the slightest, just for simplicity. I have an SKR Mini E3 V3.0, a TFT35, and BLTouch on there way in the mail, which I'll be installing on the printer, initially just with Marlin 2.1.X bugfix. I'll start with what I'm running: Ender 3, MicroSwiss direct drive and hotend, RPi running Repetier Server, and other parts that I think are irrelevant to the topic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |